How To Install Bubble Bushings

Bubble bushings set how loose or tight your fingerboard trucks turn, and swapping them takes just a few minutes with a fingerboard tool. Here's how to install Pro Duro Bubble Bushings and pick the right durometer.

Quick answer

Take off the kingpin lock nut and lift off the hanger. Put one bushing on the kingpin with its wide side up, set the hanger back on, then add the second bushing with its wide side down, so the wide sides face each other with the hanger between them. Thread the lock nut back on and snug it down without overtightening. Each truck uses 2 bushings.

How to install bubble bushings

  1. Remove the current tuning. Use your tool to take the lock nut off the kingpin, then lift off the hanger and the old bushings or O-rings. Keep the lock nut somewhere safe. It's tiny and hard to find if it drops on the floor.
  2. Add the bottom bushing. Slide a bubble bushing onto the kingpin with the smaller side down against the baseplate and the wide side up.
  3. Put the hanger back on. Set the hanger onto the kingpin, on top of the bottom bushing.
  4. Add the top bushing. Slide the second bushing on with the wide side down against the hanger and the thinner side up. The wide sides of the two bushings should face each other.
  5. Put the lock nut back on. Thread it onto the kingpin with your tool and snug it down.
  6. Repeat on the other truck.

Don't overtighten the lock nut. Cranking it down squeezes the bushings, and overtightened tuning won't last as long. The bushing durometer is what really sets how your trucks feel.

Pro Duro Bubble Bushings installed in fingerboard trucks

Which durometer should I get?

Pro Duro Bubble Bushings are custom molded from an ultra-premium silicone with a consistent shape and hole placement, in three durometers. A lower number means a softer bushing and a looser turn.

Durometer Feel Good for
51A Extra loose The most responsive tuning we offer, with the widest range of truck movement
61A Classic loose The same feel as our OG bubble bushings. If you're not sure, start here
71A Medium Tighter and steadier, for dialing in technical tricks

Each pack has 5 bushings. Each truck uses 2, so one pack tunes both trucks with a spare. Gen2 Prodigy Pro trucks also come with a set of 61A Pro Duro Bubble Bushings in the box.

FAQ

Which way do bubble bushings go?

The wide sides face each other, with the hanger between them. The bottom bushing goes wide side up and the top bushing goes wide side down.

How many bushings does a fingerboard need?

Four, 2 per truck. Each Pro Duro pack has 5, so one pack does both trucks with a spare.

Which bushing durometer should I start with?

61A. It's the classic loose feel, the same as our OG bubble bushings. Go 51A for looser trucks or 71A for tighter ones.

Should I tighten the kingpin nut to make my trucks tighter?

Only a little. The kingpin nut adds some tension, but the bushing durometer is what sets how the truck feels, and overtightening wears your tuning out faster.

Will Pro Duro Bubble Bushings fit my trucks?

They fit all major fingerboard truck brands, including wider-kingpin trucks like Dynamic and Y-Truck.


Leave a comment

Please note, comments must be approved before they are published

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.